- ATR large rear swaybar is good for what?
- anyone ever find a diff hyd roller lifter
- A/C high side pressure Radiator fan switch
- advice
- relocation of power stroke intercooler
- Next upgrade?...wedding anniversary gift
- Big cam mistake
- AC question
- flycutting
- Ford 9inch or Rebuild 8.5?
- What Rockers are these?
- What Rockers are these?
- cometic gasket torque?
- Crower Buick roller lifters, pics inside
- Misters for additional intercooler/radiator cooling
- I'm stumped- no start/run after cam breakin...
- cup holder idea
- front seat back upholstery
- Check valve
- 2 Questions
- RJC FMIC and turbo fit
- Fuel Pump grounding out
- Just bought GN and Looking for Help
- intake fitment
- Anti-theft help?
- Wastgate Question
- Iron Champion Head Spring pressure too High
- what are blms?
- Do i need a Deep Sump Oil Pan?
- kr building boost, gone at wot
- weird noise?????
- Who all sells replacment rear springs?
- hood pad
- ebay HEADERS
- Aftermarket 87 GN Analog Fuel Sending Unit
- I need a catch can.....
- What motor mounts should I get?
- Intermediate (Steering) Shaft Coupler
- induction question
- fuel lines
- Help/advice tuning with the MAFT Gen II
- Black wheel studs
- Is 105 lowest BLM# possible?
- What could cause this?
- a/c problem need some help
- ? for engine builders... ring gap
- RJC Mega Cooler??? results
- Direct Scan File
- How do I post direct scan file
- Where to buy ?
- Hood Insulation Pad??
- Oil Oil everywhere !!!!
- Rear Main Seal
- Knock Retard???
- Cant build boost with stock turbo until 2nd!?!?
- BLM woes
- miserable 60ft time
- vaccum ?s help!!!!
- anyone running the new turbonectics super 70
- Direct Scan
- ? overcooling engine oil with external coolers
- Best 83 injector chip
- LMA-2 Config
- Crankshaft comments/suggestions
- How to test Egr valve?
- Car stumbles only in 4th gear
- What is the best way to hookup a winch to pull a GN onto a car trailer?
- Converter wont push up to flywheel completely?
- Oil smells like fuel...
- what happens if you install cam sensor wrong way?
- Trans Cooler as an engine oil cooler?
- LC-1(Innovate Wideband)+ Gen 2 MAF Translator
- cam help
- Trivia Question
- Top Engine Cleaner?
- Scanmaster Numbers...
- Injector o-ring lube.
- HELP! my father's '87 GN was submerged in 3 ft
- Aftermarket Headers
- Very loppy idle
- Need help with CAM install / removal
- Can anyone identify this heater / water pipe??
- AC Blower Speed
- Still have problems
- Buick shop in Michigan area
- Oil temps
- Is the turbo to block/head bracket necessary...
- smoke smells like oil
- Will any chip work with RJC Power plate?
- Which cooler?
- Fuelpump not priming
- service engine soon light
- Installing RJC FMIC
- Just wondering if anybody else has this happen
- chips
- EGR Hoses
- buick info thank
- Where can I find the PCV one way valve and the correct PCV?
- int part number
- Driveshaft removal/installation
- First trip to track with questions
- Cracked block need advise!!! sorry so long
- Coolant temp sensor..best place to buy
- Trans Am Wheels for GNX Clone
- Wide Band?
- does anybody have a cam sensor near me?
- backfire problem
- Part # for BHJ balancer.
- More SM readings...again
- cold start trouble
- Front bumper fillers
- code 41 and no start
- 72lb. inj.
- Quick question on GN1
- Safe to run 21 psi with 93 gas?
- Interior light stays on.
- Rim screws
- Anyone have pics of GNX style dash??
- KNOCK ?? Not showing at all on my scanmaster
- what's all needed to go mafless
- Back from 1st time at track.
- Front Mount And Engine Cooling?
- how can i check 4 a blown head gasket
- M&A head valve cover gasket
- Just got my A/C finished!!
- GNX Fender flare molding?
- Autometer Electronic Fuel Pressure guage problem
- anybody know anything about this chip?
- 65lb injectors NOT motron
- help,86 g.n runs like it has a rev limiter
- Rear Seat belt bolts...
- Test pipe for Hooker catback with 3" DP?
- Votage Problem (Please Help)
- won't rev past 4900rpm?
- one fan running one not
- eliminating Wastegate Solenoid
- what injectors do I have?
- Comparison test 3.8 vs 4.1
- Intercooler ?s
- running rich
- Car doesn't start after 10 minutes!
- next upgrade worth the $$?
- New Combo?
- Stock PCV and high boost
- Need a GM part number
- Engine Warranty Help Needed (soap opera)
- Where to buy crank sensor mount bracket?
- 02 Placement
- Grounds
- Dyno Referral
- Trunk Hinge Rattling - How to fix it???
- Need some help with A/C
- ramcharger fan question
- looking for these hood pins. have pic
- fan speeds
- seats
- Car wont start
- your oem gas door stays down
- Bushings bushings bushings
- Yet another tuning problem
- quarter stick
- Porting stock heads, need advice
- gas in oil
- WG solenoid
- Oil cooler install....
- Car Stubles at VERY light throttle
- Delay Relay
- Combination questions (long)
- Production vs. stage 2 cams
- Swapping Injectors
- Need pix of manual boost controller installs
- Aluminum Vac. Block
- looking for mechanic in SF bay area
- Direct Scan software upgrades
- 3 guages to get, but which ones?
- I know that this question has been beat to death but...
- What do YOU do about this High BLM condition?
- blow off vent
- Headgasket???? Water bubbling in resevoir & overheating
- Code 31 Scan Master...
- Chip question
- Nos-15763 fuel pump help needed asap
- Leak at the rail!
- Electronic Climate Blower Motor Resistor Needed
- reusing main caps on a different block?
- Boost line
- power window
- tps #'s
- Blms
- Volt light on?
- What exactly is F41 suspension??
- Knock at 1-2 shift, why?/Timing advance 1st and 2nd?
- Where does weight gain come from on a 87 GN vs 87 Turbo T?
- Part Number for the turbo oil drain gasket......
- EFI University...anyone ever been?
- Check valve for valve cover breather?
- Solid roller, Crower, Isky,
- Doing Dutt. neck mod....have a ? about it
- Correct main stud installation
- 85 to 87 computer converstion question
- Clip/clamp
- smoking
- NEW PLUGS & WIRES
- Oil sender/turbo feed brass "T" Where can I get another one?
- Question ablout delay wiper lever
- PCV Stuff
- 1a auto weatherstripping?
- What is this?
- Took the car out and new issues
- Finding an oil pan front lip gasket
- want roll cage installed......
- Battery relocation
- repairing trunk carpet kit
- New Fuel Gauge
- Couple Air bag questions??
- Suggestions Needed for 15" Tire Size w/Eibachs
- PT-67 Stall
- fuel pump issue?
- Lifter tick
- Need Factory Lug Nuts for Turbo T Wheels...
- BLM's and o2's
- SS Engine Bolt Kits
- Car won't make boost
- Car won't rev past 4350 RPM!!!!
- Fuel pump prime doesn't stop
- Poor dyno numbers?
- Anybody using 60 lb / hr Montron injectors
- Starting a car thats been sitting 2 years
- RJC megacooler " excellent "
- No radiator pressure
- Steering column replacement issue
- quick cam question
- Search for new headers
- Wow here's an odd one...code 24
- No more laptops
- Anyone have bone stock dyno, 1/4 times?
- M/T ET Street (not drag radial)
- Tips on removing my front bumper because of rattle.
- Fuel Gauge Not Working
- Benefits and downfalls of an underdrive pulley?
- Thumping Sound
- Strange fuel pressure issue
- gm part numbers plz.
- Best turbo for a basically stock motor..
- Where to mount the LM-1 controller?
- Where does the stock trans cooler mount?
- TTA time to upgrade!
- what is this?
- WOT tuning question
- stupid u-joints