- AC compressor question
- Dual A- pillar Guage pod, which is best?
- no more than 15 psi
- positive cable lead loom
- THDP conversion
- Fuse Panel Screws??
- Fuel/Octane
- need walbro fuel pump filter #
- Know of any ?
- Dead Digital Dash ?
- Where do I find...
- Motor mounts??
- Tempermental AC
- Brake pedal goes to floor....HELP
- lo blm cured
- need help with gen 2 maf translator
- grand national looses power at 55mph
- engine stuttering
- Knock check for a dummy
- Remove A/C?
- Exhaust Leaks
- Engine missing questiong
- Leaking Oil - Engine Girdle
- Parts needed to switch to steel braided fuel
- Pushrod Help
- need help seting translator
- 82 n/a motor ?S
- Fuel Return Pressure?
- Stupid question......need a quick answer please....
- Cooling system blends (summer/winter)
- O2 Sim
- Beware of bad gas.
- Rear brake adjustments
- What is this part...under horn pad?
- wheres it at
- Dealer Installed T-top Weatherstriping
- Dual Fans
- Lots of smoke (possibly turbo?)
- So here is the thing ........
- What adhesive to use on magnet inside rear end cover?
- Tuning help, low O2mvs
- Possible sources of knock?
- Hot Day = No Start
- Headers SS Auto Chrome ?
- Brake Part
- LT-1 mini-starter bolts
- New to turbos, not new to engines. Have a couple questions..
- Ticking Noise
- fuel pressure reg. rebuid kit
- fuel pressure reg. rebuid kit
- fuel pressure reg. rebuid kit
- Twin Turbo Regal?
- slow boost
- Two questions
- so rich that it smokes you out
- blower motor info
- hate to ask another lo blm question but...
- ATR 7th Injector Instructions
- What happend?
- Help
- advice wanted
- Another Newbie
- newbie questions
- How do you wire a remote fuel pump switch
- Too much oil pressure.
- A/C Delete who has done it?
- Which alternator?
- new guy need help tuning
- Rear Main Cap
- ARP head stud part # for 85 block
- Need help: Fuel pressure problem
- HP problems wonder why? and can it be welded
- New 87 GN Owner
- fp drop
- Drain Old Gas or Keep It?
- Column shift = 700R4?
- How does the factory waste gate actuator work?
- Chrome alternator for Turbo buick....
- Twin Turbo 454?
- Air Filter sizing
- Options for intake gaskets
- Rear main seal...
- egr vaccum line keeps blowing off
- cant find a PEVR
- Not running right, checked compression
- Where to find wheel well trim?
- Need bolt sizes
- 15 lbs boost and thats it
- 3.625" Stroker cranks
- How big with stock ecm
- Accufab or Kirban Fuel Pressure Reg?
- Wont Stay Running?????
- 2-3 shift and FP
- scorpion rocker arms
- OK to wire gauges in tandem?
- Blow off valve install???
- Got an A/C question please help!
- Ramchargers dual fans
- question about my car leaning out.
- Fan Motor Relays need part #'s.
- whats the weight?
- Does the 3800 Series II heads fit the GN?
- Slp Maf
- Remote power trunk installation
- No Boost Question
- Cam gear installation
- Power seat wiring
- BIG dilemma!!!!!!
- Faaaasst Power Windows?
- Identifying Injectors
- Need to change my belt in an hour
- Dash panel screws
- Rear end fluid POSI
- Popping over 20# of Boost
- O2 millivolts Keep Dropping!!
- Bad ground???
- I've got an engine noise... (Video)
- Head Gasket????
- 50 lb injector problem
- Turbonetics 70 P-Trim
- clock question?
- EST module?
- Head Flow #
- engine stored for a long time?
- Wastegate actuator bracket?
- Need Help With Ram Chargers Fan
- Won't Blow !!
- Trunk Battery Relocation
- Caspers cam sensor cap issues
- Brisk spark plugs
- update on my free motors
- Brake Problems
- Looking for 4.1 info
- More KR Woes!!
- Tach question
- Motor is going to machine shop...help
- 10mm wires Vs. 8mm wires
- Breaking up on the top end
- ECM questions
- RJC power plate ?'s
- Dog House Engine Lift
- oil dipstick smells like fuel
- Quick...3bar MAP part#
- Info
- Coil pack removal issues :( HELP!
- Vacuum help please
- turn signals slow
- Trouble with shortblock assembly
- torque converter solenoid
- RJC intercooler/need help
- Stumble at light throttle fixed!
- A Not-So-Adjustable FPR
- Gm Eos
- can someone post pics of 325/50/15 dr mounted
- ATR Dpump question
- Oxygen Sensor located on the Test Pipe
- Best bearings to use on eagle crank
- No Start - HELP needed ASAP.
- 02s & BLMs
- 87 gn
- Is this an AC Delco MAF?
- Time For New Header Gaskets...
- Odd problem...
- UMI Lower Control Arms
- Crankshaft on Ebay
- timing chain q's
- Rebuild Time!
- New Myth...... ah maybe not.
- Exhaust Leak?
- vacuum leaks
- Cam guy's in here...
- Bigger pushrods?
- fuel pressure
- Cam/Lifter kits that dont wipe lobes...
- Oil, zinc, and flat tappets.....
- Factory Tach
- What should i do about my motor?
- SE Turbo SS header
- HP limits of stock intake manifold
- Anyone familiar with master power turbo's?
- Which 60 lb injectors?
- Smoke out valve coverbreather?
- Noisy Valvetrain?
- translator+ wont plug into gm harness?
- t70 to big for stock block?
- 87 no turn over
- engine bearings
- Different width cam bearings
- home made cold air
- Combo Swap, Expected Gains?
- More BLM????
- Need help ASAP on thermostat install
- who sells a chrome reservoir cap
- Idling problem 87GN
- RJC Gaskets (not just head gaskets)
- Installing Kirban Driveshaft loop
- 500 HP - 500FT/lbs torque
- fuel and chip questions
- How to test a wastegate selenoid ?
- member needs help
- Radiator rubber insulators...where to get them?
- Valve Cover Replacement
- Fan Resistor specs?
- Turbo, headers glowing red
- downpipe question
- need the best head gasket
- Jax Slip On Seat Covers
- Crank Failure ?
- lazy maf?
- Motor Fan
- To the naysayers of 3" single exhaust
- ignition/injector timing
- Have you ever heard of this?And is it any good?
- Solid Roller Cams
- Fix my seat...please?
- Question for the engine experts...
- I've got some work ahead of me
- ATR large rear swaybar is good for what?
- anyone ever find a diff hyd roller lifter
- A/C high side pressure Radiator fan switch
- advice
- relocation of power stroke intercooler
- Next upgrade?...wedding anniversary gift
- Big cam mistake
- AC question
- flycutting
- Ford 9inch or Rebuild 8.5?
- What Rockers are these?
- What Rockers are these?
- cometic gasket torque?
- Crower Buick roller lifters, pics inside
- Misters for additional intercooler/radiator cooling
- I'm stumped- no start/run after cam breakin...
- cup holder idea
- front seat back upholstery
- Check valve
- 2 Questions
- RJC FMIC and turbo fit
- Fuel Pump grounding out
- Just bought GN and Looking for Help
- intake fitment
- Anti-theft help?
- Wastgate Question
- Iron Champion Head Spring pressure too High
- what are blms?
- Do i need a Deep Sump Oil Pan?
- kr building boost, gone at wot
- weird noise?????
- Who all sells replacment rear springs?
- hood pad