- I Have 3 Problems, Not . Please Help...
- stock engine
- Any good Turbo Buick Shops in Ca.
- Oil pan removal with engine in car???
- Anybody have installed pictures of TA headers from the bottom?
- Will an 84/85 style coil pack work as a replacement for the 86/87 style coil pack?
- Good brand intake gasket for 86 Gn?
- Connecting Gen II to stock wiring harness
- Knock Gauge question
- New Gn before and after pics!
- 86/87 MAF in 84 T-Type
- Rebuilt Stock Turbo Making Strange Sound
- Yet another Trans+ question
- It's Alive...well running anyway(its long)
- THDP what r u using to clamp the pipes
- Red VS Tweak
- Intake temp sensor before MAF or after Intercooler?
- New thoughts from previous post on warmer than average engine oil and trans temp?
- Switching to F-Body Radiator - Question
- Rocker Arm Studs
- same boost level after going back to stock intercooler?
- Difference between non turbo and turbo Regal fuel pump sending units?
- roll bar
- steering column
- TA Perfomance Valve cover question
- 60# Injectors
- Power Steering Reservoir
- Help be find Mufflers
- 3 bar MAP sensor??
- Identify return and feed (oil and tranny) ***PIX***
- T-Top Shades?
- part # for black out sweeps
- Fuel Pump not coming on- Help!
- Replacing Battery - Any suggestions
- open/close loop
- maf overheated?
- UMI tubular control arms?
- Cars going low10's - high 9's ?
- I was wondering: What if Buick .....
- Is this a turbo crank?
- Factory Knock Sensor Question?
- H&R motor mounts
- t-type -gn
- Grand National or Regal T Type
- Ram Charger Fan Question
- Translator Pro
- Passenger side power window replacement...
- Wipers not parking....
- Wtf!!!!!!!!!!
- 3" vs 3.5" MAF Pictures
- Under dash module question
- Hot wire start?
- ac compressor wiring
- which port to ground for TC lockup?
- passenger side exhaust
- Tuning question/Where to start?
- consistant voltage drain on the battery
- Trans break etiquette..
- Dyno Chart for 206/206 or 206/210 roller cam
- Uncomfortable seats....
- Tail lamp fasteners
- Battery will not charge
- Rubber straps that go around gas tank
- oil smells like fuel
- Car stalls when put in gear
- gnx dash oil pressure sending unit
- weld-in bung/fitting?????location on downpipe
- 84/85 blocks vs 86/87
- More update pics...Merry Christmas to me!
- Trans line to radiator measurements?
- Plug Wires
- translator
- Powermaster Question
- 8.5 rearend
- 42lb. Injectors - Who Makes them?
- Oil/Choke Light Keeps Coming On & Blowing Fuse
- I might need some advice on changing head gaskets
- Gnpartonline.com
- Compressor housing bracket?
- AC Vents
- GM EOS Suppliment how much to use?
- A/C does not blow...
- scanmater readings input please.
- Top End Boost and WG Adjustment
- High BLMs vs. Cracked Header vs. Fuel Pressure
- Crazy Intercooler idea
- THE WEBSITE www.gnpartsonline.com
- Using a timing light?
- Throttlebody cleaning
- Power antenna GM p/n's
- Fuel Rail Fitting
- who can review some direct scan files for me
- My scanmaster readings
- Danny Smith
- turbo buick mechanic
- Crazy Shifter Handle Problem
- Fuel pressure problem
- Anyone with current NHRA rulebook... helmet
- is cam shot?
- A/F ratio vs timing/boost
- LC-1 Where To Install Bung
- no speed!!!
- running hot
- Every Upgrade is a Hassle
- for hard top owners...
- Failed Inspection!! Brakes!!
- Main Relay On Fender Rusted, Replaces And Still Wont Start
- clunk !
- What is this port on the throttle body?
- China Headers
- Tune / Plugs
- head gasket question
- GM part #
- 12v 3-Barb solenoid
- Newbie to the Scanmaster: Readings
- Universal Joints....
- Fuse Keeps Blowing Every Time After Replacing.
- Flood Damage
- stiffen car up
- Intake flex hose
- HELP the fuel pump does not turn on the normal way
- Those using a ATR DP with cut out/dump ?
- Electronic Climate Control users
- Effect Out of Spec TPS Voltage?
- fuel pump
- roller rockers
- Fuel pump questions
- Scan Master readings Aug 22/07
- Fusible links by starter melted on header, Are they available anywhere?
- Oil temp on a Gn? Car has a gauge, seems hot to me?
- Stereo replacement
- No Start After Washing Engine
- Could someone check their GLOVEBOX
- Gauge Light Problem
- Please help with AC....
- Motor mounts ????
- Trying to figure mph
- Should I upgrade injectors?
- Reds Double Pumper
- Vacuum reading at idle
- Full Throttle`s 4in pipe w/built in MAF
- fuse block
- hotwired coils/ign
- Need broken MSD DIS-4's for research project
- dyno tunning
- MAF trans problem
- nger side Running wires through the passenger side of the firewall?
- Stock Gn wheel, car lowered 1.5 inches, Tire size??
- Does this sound like a header problem?
- Install directions for Scanmaster??
- K&N breather leaking oil on passanger header?
- Replacing power steering gear...which ratio do I need?
- 4 bolt cat back flange
- Waste Gate
- GN Dash mat / cover
- OK to re-use Crankshaft cap bolts??
- MPG's need help
- acctuator ?
- blown head gasket?
- Finally, Suspension Rebuild is Done! But new problem......
- What failed first?
- valve spring tool
- collapsed NEW lifter
- Is this the right console/shifter?
- Sensor????????? (87 GN)
- Under optimized combo
- Now what?
- Where to find NOS Blackout door locks
- can swap
- Need more Tach Juice
- Weird power antenna problem
- 110 vs 118 octane
- TT IIs?
- New Gn runs terrible???
- Intercooler brackets, where do I bolt them up?
- Need help with troubleshooting
- Knock detector question
- Underpowered w/ Mods??
- Time to replace EVERYTHING! (pics of my project)
- Pulling motor out
- amp draw
- What's the best source for new door channel weatherstriping?
- Fmic ?
- how to stop the window rattling in the door?
- what size injectors
- brake switch wiring and lighting questions
- Mr. Licht....Full Throttle
- Roof Replacement
- .080 plug gap
- now stumped: MPH bouncing all over on scanmaster in park and driving? anyone,HELP!!
- Security System killing battery... HELP!
- Broken block or poor casting??
- Looking for some info about car and ANS performance
- Question about oil pan gasket mating surface
- Oil Cooler Adapter O Ring
- Great Brake idea, is this the answer to all of our problems??
- Turbo Meter Pro doesn't work
- Fan problem
- Heat/Ac box removal help!
- Almost done the engine, teaser pics
- just had car dyno in brooklyn
- Still Getting Code 45
- Need a TR Tuner Near Palm Beach
- champion valve covers
- Who makes the biggest front and rear sway bars???
- installed TA49.......problem
- little or no boost
- Why won't my relay work?
- gn seems slow
- NE 1 Know the size of machine screws in cam sensor cap?
- Anyone sell NEW stock replacement plastic wheel wells?
- Pinout help needed.
- Aluminum Radiators
- Need HELP
- 87 GN Performance questions
- engine harness replacement
- Looking For A Radiator
- Kinda quirky problem!
- Comments on 3" single shot exhaust PLEASE
- Gm Turbo Oil Drain Pipe
- Poor performance, Low timing?
- Help me ID this sensor
- spark plugs
- 55 # injectors
- Ebay Front Mount Intercooler
- tps sensor question
- How are these compression #'s
- Is this a good cam package>>>>
- Transmission Deep Oil Pan
- Only .660V to CCCI???? HELP!
- Crossmember Help!
- EOS find
- engine strap
- stock Gn/Ttype rim back spacing
- "Knocking" noise coming from front of engine?!?!
- More Newbie help needed !!
- Hook up wastegate solenoid or 'tuner style'?
- Where to buy replacement Headliner
- WOO HOO ordered an set of TA Headers today
- Need tires
- Fuel pump questions
- Intercooler Shroud
- Anyone know driveshaft length
- I Need Parts Proformance For My 84 Gn
- Speedometer Cable ?
- RJC oil pan
- Autozone"s 160 Thermostat
- Engine oil and filter
- need help getting GN to run right. In Alabama
- Bad MAF Sensor??!