- New to buicks.. Have some ??'s
- need engine pics
- Painting an intercooler
- Radiator and overheating:
- Are the three rubber hoses from the fuel sending unit available from GM???
- New valve springs/timing gears??
- guys with TH400
- Hurst Lighting Rods
- Plug for passenger side valve cover?
- yet another manual boost controller question
- Where can I find a custom gauge panel?
- Idle issues, temperature sensitive MAF?
- kinda new member
- Looking for budget rebuild ideas
- ?????bucket seats?????
- No traction on the street with MT ET Drags
- didn't know where to post this but re: Kenne Bell valve covers
- posi ???
- What Chip??
- aeroquip socketless opinions??
- breather
- IAC angle adaptor
- Shifting Questions
- TTA front mount modification
- Bearing wear
- Max boost from stock actuator...
- Dex-Cool or Green Stuff for Aluminun Radiator?
- RPO codes
- Cold Oil!
- Throttle body
- GM tabs?
- New to forum
- Champion Fuel rail w/ external FP Regulator
- Question On Oil Feed Line To Turbo
- Dash swap-out
- Has anyone used this down pipe?
- dfi ?
- External Trans/Oil Cooler
- Exhaust System
- Power Steering
- Anybody on this board do any metal polishing??
- chip questions
- GN/T-Turbo - Practical as a daily Driver?
- where do i install chip??
- Brake pedal clip
- problem with over boost, fluctuating...
- Pictures of slack in timing chain
- Stock header gasket?
- gage pod holder?
- Bruce Plecan's turbo surge remedy works.
- Spring Cleaning.. what happend to the gas mileage?
- Samballz 3.5 Downpipe
- Seat covers 50% off?
- Powerstroke install progress pics
- oil pressure
- What gains from new exhaust?
- How fast on stk IC?
- Fuel questions
- DS Remote Mirror cable (which access hole on the inside)
- the right spark plugs
- Fuel gauge diagnosis
- Part numbers required for Posi Clutch replacement
- Annoying noise in the dash!
- Coil pack torx screws
- which SEAT COVERS should i get?
- Cold Running Problem
- How To Remove The White Part On Bumper Strips?
- Need Help Finding A Trouble Code
- weight reduction
- Transmission Shifting Question ?
- Pt8847 Turbo
- g body parts oil feed line
- WE4 availible Colors
- My header /crossover flanges = leak free
- oil feed line steel braided
- oil pump clearance help
- dump pipe ?
- What is the most stock appearing performance shifter?
- BOV Placement
- SS TR Headers on Ebay
- S10 Wheel cly. causing brake pedal travel?
- Fiberglass Bumper Users
- Wideband Question
- Who sells 3" down pipes?
- No Boost Gauge/No Knock
- Problematic start up after motor is warmed up...
- 8.5 Rear Weight
- Vss
- power tap for tach/electric cutout
- Fast Times on MT Drag Radial 235/60/15
- injectors?
- should i use these spark plugs?
- Tach
- Rear Alluminum drums.
- Hollow F-Body Sway bars
- GNX turbo Identification
- Fuel Pump Fuse Keeps Blowing
- Looking for someone to help tune
- Intake porting question
- Recommendations for bushings/hardware source
- gbody phone number
- Won't run, should I buy??
- Olds Hurst Lighting Rods
- rear main seals
- Min. fly wheel to converter air gap?
- Back Spacing
- Oil pump spring press ?
- questions on undercoating
- Just Bought a Scanmaster 2.1?
- Polishing the throttle body?
- Will her rear-end work?
- Selling my Daughter
- Whats the point of a decent downpipe?
- Thank's
- Volt light flickers
- 87 GN Turbo Question - n00b To The Board
- rebuild and machining cost
- Looking for experiences with Double Pumpers
- #Checkballs
- Turbo shield question
- car problems
- Dumb Computer Chip question
- car running funny after adjusting brake pedal switches
- any ideas
- timing cover and chain question
- looking for more power
- best upgrade?
- 1st experience with alky
- INQUIRING.... Jax's Leather Seat Kit
- Buick 455 in 83 Regal
- Is there any trick to keep the sock on a fuel pump?
- Interior door panels and dashboard questions
- Rear Floor Mats
- Reseal studs when changing HG ?
- Hose
- vin #'s
- Muffler ???
- Bone Stock
- Why I'm I getting a -99 ATS on the Scanmaster?
- In search of advice/direction.....
- I just can't win!!!
- New GN, problems need advice...
- New guy here, could use a little help...
- buick231/holden v6
- injectors
- GM front bumper fillers
- Seat belts
- Help,problems with idle
- please identify this chip
- Bottom shock bolt in the way
- Impala SS or LS1 MAF
- Cooler air in intake
- Stock floor mats
- bottom of Intake
- New build, can't get idle below 1525 rpm
- Widest Tire on a 15x8 or 16x8 rim?
- looking for a tial 38mm wastegate
- MAF Translator+LS1 MAF
- Boxed LCA ?
- Fuel Pressure
- boost dropping off
- Chip?
- Any tall dude's out there?
- Additive question
- What's it take to lift the front wheel(s)
- How-To: Re-fit Door Pull Strap Screw Holes w/Nut Rivets
- intercooler NOS
- Stock Thermostat
- Acu-Fab Re-build
- Anyone using BuickGN.com Mark Hueffman gauge panels above the glove box?
- Upper RPM break up
- Anybody hear of Nokian Tires?
- need help please
- thdp
- Help With Connections On Throttle Body
- Lit if off tonight runs great
- Stock turbo & Untouched Engine--DRAG TIMES????
- What the heck?
- how do i get seat covers off?
- AC Delco or Bosch?
- First run since 2/2006
- Check out these cams
- SS 2.5 Cat back
- Has anyone ever used 5 star shine car wax on their turbo buicks?
- which c clip eliminator kit?
- Anybody know what year LS1 MAF???
- 3.5" dp
- Can you tell if a RJC PP is installed without...
- Are All Turbo Gas Tanks Junk?
- Somobody posted really nice pics of their GN frame all boxed, Please repost!!!
- Where can I buy fuel socks for double pumper?
- ECM wiring identifier
- 8.5 rear 10 bolt
- electric or mechanical gauges?
- Oil Pressure woes....
- Injectors?
- Which one would you buy???
- Oil for cold conditions
- O2 Reading Bouncing
- WBO2 question
- Extreme rich condition cause knock????
- scan tool ? laptop? how to best tune my T-type??
- heater core leak?
- Just Bought a Scanmaster 2.1?
- In the process of boxing the frame, any other places that should be reinforced?
- Oil Pressure Question
- E3 Spark plugs with Diamond Fire Technology
- intercooler hoses
- Maf Translator Gen 2 settings
- Name that part
- Energizing Fuel Pump
- knock and fuel pressure problem
- Help with rust..
- Translator
- HELP!!! Timing issues
- Relocating SMC tank?
- WB02 install pics
- What size down pipe should I go with?
- cooling issue
- Exhaust flange dimensions
- Oh NO! You guys are gonna hate me!
- Downpipe question
- brakes
- spooling ?
- 3.5" MAF Sensor or 3" MAF Sensor what is better
- Took My Baby To Her Final Resting Place Today(pics)
- I'm in Car Craft!!! (and its tech related)
- wiring diagram
- what size hardware?
- sensor id?
- Fiberglass Parts
- Question about the car starting up...
- F-body radiator questions
- Is this right?
- Header, CAI questions
- Remflex header Gasket?
- Turbo oiling question
- Radiator ?
- ATR liquid to air intercooler
- Those that have had luck with hyft cams.
- in car crank removal
- ? EXTENDER chip OK to run with Stock MAF sensor? YES OR NO
- Identify injector size
- Remote oil filter questions
- Fuel Pump Stays On
- Setting Cam Sensor
- Frustrated Guy
- Radiator question
- Coolant System Pressure
- lights