- scan master wanted
- Hot Air Downpipe
- 3" Stainless Test Pipe - Oval for ATR
- Looking for a spare rocker shaft
- Wanted: Stock Vacuum Lines
- Wanted... set of junk wheels/tires
- Xp double pumper
- WTB 3" Pitbull mufflers
- 50 lb chips, Translator plus, and LT1 MAF
- Tranny part needed
- set of GOOD heads,glass front bumper,valve covers
- looking for excellent condition upper door panels
- Roller Rockers
- GN RADIO with EQ
- Roller Rockers and/or camshaft needed
- Steering wheel
- Hard Vacuum lines.
- Looking for a accumulator ball.....................
- WTB ta-49 turbo !
- Kind of an odd request...need a pitman arm
- Scanmaster 2.1
- Te 44
- WTB::: stock intake
- .030 piston ring set
- stock i/c
- Bhj Internal Balancer And Turbo
- The black air deflector that looks like a mat...fits under radiator???
- gn1 front mount
- External Gated 3" Downpipe
- 87 gn stock wheel center caps
- WTB- New 86' T-Type Grill Emblem
- WTB NOS Right Front Wheel Well Moulding
- GNX cat back exaust
- WTB Black Parking/Turn Signal Light Bezel
- Power steering reservoir
- Tta Aftermarket Downpipe
- WTB: Fixed mast antenna
- Need some parts
- looking for a few things
- Looking for a Turbo & 3in Catback
- Looking for an Accumulator for powermaster
- Browsing for low mileage or rebuilt turbo and ported elbow
- Rear cover for 8.5 gn
- WTB: 4" pre-turbo piping (MAFLESS)
- Stock Shifter cable.
- set of draglites for my regal
- Stock up pipe
- Engine Lift Hook
- Delta Gate block off plate
- Wanted: -8, -6 Braided hose and Powerplate
- BMS Balancer
- *Complete* Scorpion stud/rocker kit for 14 bolt GN1's
- carburator bonnet
- Turbo
- Valve covers
- WTB ATR Sway Bar
- WTB GN Trans Governor
- Cam Sensor Tool
- 50lb injectors,16" Drag radials,3200 stall conv.
- factory 87 exhaust hinger
- crossmember for th350
- pvc groomet
- Need engine...
- 4 t-type rims with center caps
- drivers side intercooler bracket
- Accumulator Ball....
- Looking for 3" mandrel bent dual exhaust with behind the wheels exit.
- WTB Mint DS seat...
- Wtb: 3000-3400 Stall Converter
- 87 T Type Center Caps
- Looking to see whats out there on a Short Block or Long Block
- Looking for 3.8L N/A or Turbo block 81-up
- Power Master Pressure Switch
- WTB TE44 or TA49 - Turbo for stock convertor only
- front bumper fillers
- AC setup
- WTB: Champion Fuel rail/for external regulator
- Looking for Black Belt mouldings
- need this
- plenum spacer ASAP
- Looking For A Test Pipe
- drivers door
- Front Mount
- Wanted: Stay down gas door / license plate holder
- Gn factory Radio
- GNX imprinted Rear end cover wanted
- WTB: Grand National Taillight Blackouts
- wtb few interior parts
- tires and other things
- Looking for a nice stock Cat converter
- Radio Bezel
- Looking for trades, I have alot of parts
- Looking for a set of NOS GM REAR bumper fillers
- 3:73 Gears
- gauges
- Limited door panels and maybe rear seat
- oem black T center caps for sale or trade
- Gnx Dash Bezel And Applique
- Wanted: MAFT Pro Plug and Play Harness
- 3" thdp and cutout
- 10.5mm Ingition wire separators
- WTB: New Coilpack and Module for 86 GN
- wtb console mount dual gauge pod
- Looking 4 a chrome or polished rad support
- WTB: 84/85 Hotair Turbo Drain Tube
- spoiler piece needed.
- WTB 3200 lock up converter.
- Looking for an 87 GN engine and trans
- Stage II Wet Sump Oil Pan
- Wtb-tv Cable And Ecm
- Powermaster Unit
- chips 50 pound injectors
- WTT vacuums blocks
- WTB: NOS analog speedometer cluster for '87 TR
- Hot Wheels 68's in Black 17x8
- MaftPro Translator
- Need 85-87 complete running motor FAST!!!
- Need 85-87 complete running motor FAST!!!
- WTB 85-87 GN complete engine
- Weld Pro Stars
- Rear lower control arms, ATR sway bar
- Fiberglass front bumper for 85 Regal
- hot wheel sixty eight wheels
- WTB: 20-bolt Stock Oil Pan & Stock Balancer
- WTB 109 short block
- TE-44 Exhaust housing
- 86-87acessory bracket
- WTB:ported turbo elbow
- Body Bushing Needed..Help!!
- T-top headliner
- 2.5" up pipe.
- extra timing cover bolts
- wtb rear air bags
- coil spring bushings
- 65mm Throttle Body
- looking for chrome
- window regulator
- 120# or 160# injectors
- Need window regulator and power window motor
- 2004R Pan Needed
- Pass.Fender
- Need good stock turbo
- Parts
- looking for a stock motor
- .63 or .82 Garrett Exhaust for "P" Wheel
- Wanted THDP
- wanted slicks and rear seat belts
- 8.5 buick rear
- wtb 87 turbo t centercap and rear spoiler(gn)
- WTB: 3000-3200 converter
- WTB used drag radials
- looken for looken for a gn1 front mount(or equivilent) and a fiberglass front bumper
- Wanted: 3200-3400 l/u Converter....Possible Trade?
- coolant lines
- ATR Crossflow exhaust
- Need a scanmaster...
- Need oem rear bumper fillers
- 86-87 turbo buick engine accesories needed.
- wtb headlight bezels and header panel
- B pillar trim
- Wtb Downpipe Asap!
- Standard bore Pistons
- GN front seats
- GN Headrests.
- Limited parts needed
- Looking for a nice downpipe
- Stock shifter cable
- Needing hooker parts and emblems
- Looking for Blue interior pieces
- Comp Engineer 90/10 Shocks
- Looking for a Radiator hold down brcket.
- WTB ecm top cover,seat track trim,magazine
- passenger side rear bumper filler needed
- gauges
- In NEED OF built 109 short block or long block
- wanted to buy- fuel pump controller
- Ported Stock Elbow
- WTB: Stock GN Floor Shifter
- Alum. Front and Rear Bumper Supports
- Wheels/Tires
- Good used Flat Tappet or Roller Cam set
- Looking to trade my 83# injectors for 96#
- ATR 3" Mufflers
- wtb 60lb injectors & tt chip
- Aluminum Bumper Supports
- 3'' Internal Or External Downpipe / Intercooler
- 3'' Internal Or External Downpipe / Intercooler
- WTB 8.5 limited slip drum to drum
- Steering Wheels and fuel injection relays
- wtb sand/beige shift handle and console lid
- need passenger side door.
- 87 Gn Rear Seat Bottom Mint
- down pipe
- art 7th inj
- looking for new right side tailight
- 4" MAF pipe
- Mease Performance Frame Braces
- Stock axle 28 spline for 8.5 10 bolt
- Need Engine
- 3 inch V-band flange
- 83 Riv. sunroof inside Trim
- "Turbocharged" emblem
- Wtb..
- need some parts
- WTB 1" plenum spacer
- Wtb Roller Cam/lifters
- Wanted 3.625 Cat style crank
- WTB Crank pulley,oil lines,t wheels.
- WTB: Aluminum front bumper brace
- bottom passenger side timing cover bolt/stud combo
- WTB front center bumper filler 84-87
- Help
- Drivers side stock header needed.
- translator and ls1 maf
- WTB: 60-65# injectors and 44-50 wastegate
- Lower and Upper Factory A-arms
- WTB:Adjustable fuel pressure regulator
- WTB: HV front cover, 109 short block GC
- Black headlight bezels needed?
- WTB:New Crankshaft position sensor, stock MAP sensor, and trunk carpet
- Need an 87 ECM
- Timing Cover with oil pump
- Stock 86-87 Turbo Heat Shield Wanted
- Stock Turbo-T Vector Wheels and Centers Wanted
- Original 87 Buick Regal Owners Manual Wanted
- Need a ECM.
- champion heads
- 4 barrel intake needed
- 14" test pipe w/ dump
- Aluminum Radiator Support
- 1987 Gn Exhaust
- Champion GN1 Al Heads
- pillar gauges/pods
- gm part #22038589 power antenna bracket
- GN gas tank
- Part Number for rear Bumper Strip
- front and or rear disc for G-Body
- WTB Stock Turbo Shield
- Hurst Lightning Rod Shifter WANTED
- ATR SS Stock Replacement DP
- WTB Looking for a deal on a good used ta49 or te44 turbo
- Wanted: .63 P-Trim exhaust housing
- WTB 87 GN Header Panel, RF Fender
- looking for slicks
- Need RF (Pass side) inner fender well
- The best factory looking seat covers for my 1986 T Type Regal ??
- Looking for a CAT or BA 3.625 stroke crank.
- b-piller trim
- Weld wheels
- WTB: Turbo