|
Most on here go around the front of the dash.
I can't put up pics right now but my cage goes thru the dash. If you can wait a few days I will take some pics and e-mail them. But they go thru the top of the dash. There is a small area where the dash pad, speaker cover meet near the windsheild. The bar hugs the A-pillar and passes thru the dash between the plastic speaker cover and the pillar. Only a little bit of the dash was trimmed away to make enough room for the bar to pass thu this area. It's hard to describe without pics. The wind shield had to be removed to do this but it's the best I have seen.
The best way to get the angle is to weld a bar between the A-pillars first, then tie the bars coming down the A- pillars into this bar. Then the bars coming up from the frame can be tied into the first bar. This way you don't have to bend the a-pillar bar and install in one piece. It is also NHRA legal
Last edited by Dusty Bradford : January 9th, 2005 at 07:10 AM.
|