|
o ringed heads
Ok got my motor down for rebuild right now and the drivers side head has been o-ringed. The pass side not. I am checking with my shop about getting the other one down as both heads were ported and bigger valves put in sometime in its life. Now for my question, when the heads are o-ringed do you have to run a wire in the o-ringed part or do the gaskets just push up into it when you put the heads on? What kind of gaskets would you guys recommend with this thanks Daniel
__________________
86 t-type LT 70 P-trim.63 turbo , 55lb inj, meise uppipe,pitbull exhaust from turbo back, 7th inj, hot wire kit, twin fuel pumps,volt booster on alt, LIQUID intercooler, moser axles,bags in both rear springs, 3500 pats convertor,balanced motor ,weisco pistons, GN1 alum. heads, RJC clamps,210 roller cam with T&D 1.5 roller rockers. HRparts upper and lower rear arms and Now with a Brian Hofer full built up tranny and it ROCKS! 
______________________
86 T type
68 400 firebird
79 trans am
87 monte carlo SS
57 210 post 2 door
|