|
Gary, like brian said , the only way to have the machined look is send them off and have them returned on a lathe. Most sand them and polished them out to look like chrome but you lose the machined look like that. Whatever you do do NOT use rough sandpaper!!!!!!!! Start with 1000 grit to get them clean and smooth then go to 1500, then 2000 then polish out with white rouge and a high speed buff. Daniel Ray
__________________
86 t-type LT 70 P-trim.63 turbo , 55lb inj, meise uppipe,pitbull exhaust from turbo back, 7th inj, hot wire kit, twin fuel pumps,volt booster on alt, LIQUID intercooler, moser axles,bags in both rear springs, 3500 pats convertor,balanced motor ,weisco pistons, GN1 alum. heads, RJC clamps,210 roller cam with T&D 1.5 roller rockers. HRparts upper and lower rear arms and Now with a Brian Hofer full built up tranny and it ROCKS! 
______________________
86 T type
68 400 firebird
79 trans am
87 monte carlo SS
57 210 post 2 door
|