[Jan Larsson]

So getting ready to drop the engine in place ... all empty engine bay and no transmission in there ...

Anyway, this is the plan:

- Drop engine in place (pretty complete but without the wire harness, no cross over pipe, no starter, no DP, no starter, no IC, no coilpack+bracket)
- Have transmission cooler lines in place as they sneak between the driver side engine mount
- Install transmission and connect oil cooler lines properly (can I get to all trans - engine bolts? Do the trans oil dip stick tube install after the trans is in place, TV wire already connected so will sneak that one up there as well).
- Install DP, cross over, starter, IC etc
- Fit coilpack and bracket
- Install complete engine wire harness (should I expect any problems fitting this at this stage)
- all other smaller bits and pieces ....

Any pointers, recommendations, hard to reach/install areas or order of things would be much appreciated to make sure there's a smooth install.

Also should I prime the engine while in the engine stand or wait untill it's in the car?