Quote:
Originally Posted by 89ICBM
Hi Jan!
No! You have to install it after the motor is in. There's not enough clearance to pass the K memeber. The trick to getting it on right is to leave your header bolts loose. You can then match it to the headers correctly and go back and tighten the headers. This is especially true if you used gaskets on your headers.
|
Howdy Frank,
Thanks, I got it installed while on the engine stand and everything lines up properly including my THDP so should work out well when I got it in place. Good idea to leave the headers on there a bit loose to make adjustment easier when installing the crossover.