|
Mark your plug wires so you know which one goes where if you dont have the original numbered wires still on. Then remove the torx bit screws securing the coil pack to the module. After the coils lose carefully tilt it up and back. Note the orientation of the 6 spade connectors on the bottom of the coil. Easy was to do it is take a quick pic. Use a pair of needle nose to slide the spade connectors off. After all the connectors are off you can remove the old coil. The new coil will have the spade posts pointing straight down. Do not bend them down before you have slid the connector back onto them as they are very fragile and need to be handled as little as possible. After you connect just reinstall the screws and wires and your set.
|