February 17th, 2008, 11:07 AM
|
 |
The neverending quest for
|
|
Join Date: Mar 2007
Location: van nuys, CA
Posts: 488
|
|
Quote:
Originally Posted by Jbenn911
Same as mine then.. It should be on "Pressure 100psi" "Pressure 100psi-b" is for the Caspers sensor(different voltage output)..You did tap just the purple wire from the sender and no other wires off the AM unit, yes ? I'm not sure what version of the software you have, but getting the latest version cant hurt..I did not have to adjust anything when I hooked my AM up...
edit: you can also check your voltage to see if it's calculating correctly..0.5v = 0 psi and 4.5v = 100 psi....
|
ok everything is done and i notice that in the selection screen it shows (.300) somewhere in that range but it is not showing up on data screen.
__________________
 The never ending quest for power! Turbo power!!!!!
stock motor with upgraded coil/module to 86/87, flexalite Dual electic fans, some throttle body modification, stock turbo was machined to ta33c, 2 1/2 stainless uppipe, tt chip, fuel pump hot wire, intake tubing, 60# msd f injectors, maft and ls1 mass air sensor; now just need some tuning with my new powerlogger and it should run pretty good.
p.s Thanks to all the turbo buick community for sharing their knowledge about these awesome machines!!!
|