|
March billet aluminum underdrive pulleys... belt numbers?
Hey guys,
I've seen a few threads about looking for billet pulleys for the hot airs. As has been stated before, March makes a great set of underdrive pulleys for the hot-airs. They have a much smaller crank pulley, a larger water pump pulley, and I believe a stock sized alternator pulley with a cover.
You may have to dremel out the water pump shaft hole to make them fit. The clear powder coat is too thick. You may have to do the same to the crank pulley. I have not test fit mine. My balancer is powdercoated so that would make a difference as well.
I've got a set of these pulleys sitting in my shed (Florida, no basements) because I can't figure out what belts to use. I contacted March directly and they stated that they don't have belt info for the 84 - 85's. If I had an 86-87 I would be golden!!!
Anyone running these? I need numbers for the belts.
Thanks,
Tim
__________________
Tim Paul
85 T-Top GN
GM crate motor, 87 ECM, Extender chip, 86/87 Ignition module/coil pack, vacuum brakes, 2800 stall conv., shift kit, Kevlar bands, etc., LT1 MAF, MAF Translator, Heated 02 sensor, TPS TEC, Cold Air intake, , KB headers, KB 2 1/2" exhaust, gutted cat, F.P. Hot wire kit, Walbro 340 F.P., Adjustable regulator, Green strip injectors, Electric fan, T.B. coolant block-offs, Powermaster 140 amp alternator, adjustable wastegate, 160 thermostat, Auto Meter FP and Boost gauges
Last edited by tpaul : July 30th, 2007 at 10:08 PM.
|