Quote:
Originally Posted by EightSecV6
I used aluminum rods (.300 thick at the top), but my pistons are kind of crazy looking, not conventional at all and I had to use buttons with SMALL pins!Did you get your pistons yet?Be sure to VERIFY the thickness at the center of the dish. I would not use less than .200 for the punishment you plan on putting it through and that is only if you are coating them! That is where I ran into problems but Arias got it right on the second 10. I have the cam. If I could only get a chassis to put it in......  |
No pistons yet. Waiting on exhaust valves so I can cc the heads and get my final piston specs. I swapped to a later casting head a few weeks ago and I don't have the cc size of the chambers.
I know mine will also use the buttons. My crank turned out OK, it's getting a new heat treat and will be back in a couple weeks.
__________________
PTC Converter Distributor
Twisted 6 Racing
Fastest of the fastest
Freeman, Fiscus, Kereny...who's next
85 Regal w/ turbo SBC
5.05 @ 147 on radials at 3550#
94mm and 325's
Best 1/4 pass
7.77 @ 181