salvageV6
Daily Driver
- Joined
- May 25, 2001
Anyone know the typical drain tube flange thickness on the screw on flanges that go on the braided rubber tubes the vendors sell?
Trying to set up my rebuilt (Bison) PTE-51 turbo with pre-glued gasket and studs but the studs have a 1/8" dead spot between the threads after the gasket is installed so I want to make sure it can tighten.
Too cheap to use 2 gaskets.
Trying to set up my rebuilt (Bison) PTE-51 turbo with pre-glued gasket and studs but the studs have a 1/8" dead spot between the threads after the gasket is installed so I want to make sure it can tighten.
Too cheap to use 2 gaskets.